Valrubicin Intravesical

Active ingredient: Valrubicin

In short: Valrubicin intravesical solution is an anthracycline topoisomerase inhibitor indicated for intravesical therapy of BCG-refractory carcinoma in situ (CIS) of the urinary bladder in patients for whom immediate cystectomy would be associated with unacceptable morbidity or mortality.

Forms & strengthsInjection: 200 mg/5 mL sterile, clear red, solution in single-use vials for intravesical instillation upon dilution.
LabelHikma Pharmaceuticals USA Inc.
Label updatedNov 10, 2022

What is Valrubicin Intravesical used for?

Valrubicin intravesical solution is an anthracycline topoisomerase inhibitor indicated for intravesical therapy of BCG-refractory carcinoma in situ (CIS) of the urinary bladder in patients for whom immediate cystectomy would be associated with unacceptable morbidity or mortality.

Valrubicin Intravesical dosage

For Intravesical Use Only. Do NOT administer by intravenous or intramuscular routes.

Valrubicin intravesical solution is recommended at a dose of 800 mg administered intravesically once a week for six weeks. Delay administration at least two weeks after transurethral resection and/or fulguration .

Handle and dispose of valrubicin intravesical solution in a manner consistent with other cytotoxic drugs.1 The use of goggles, gloves, and protective gowns is recommended during preparation and administration of the drug.

Valrubicin intravesical solution contains polyoxyl castor oil, which has been known to cause leaching of di(2-ethylhexyl) phthalate (DEHP) a hepatotoxic plasticizer, from polyvinyl chloride (PVC) bags and intravenous tubing. Valrubicin intravesical solution should be prepared and stored in glass, polypropylene, or polyolefin containers and tubing. It is recommended that non-DEHP containing administration sets, such as those that are polyethylene-lined, be used.

Valrubicin intravesical solution is a clear red solution. Visually inspect for particulate matter and discoloration prior to administration. At temperatures below 4°C (39°F), polyoxyl castor oil may begin to form a waxy precipitate. If this happens, the vial should be warmed in the hand until the solution is clear. If particulate matter is still seen, do not administer valrubicin intravesical solution.

For each instillation, slowly allow four 5 mL vials (200 mg valrubicin/5 mL vial) to warm to room temperature, but do not heat. Withdraw 20 mL of valrubicin intravesical solution from the four vials and dilute with 55 mL of 0.9% Sodium Chloride Injection, USP to provide 75 mL of a diluted valrubicin intravesical solution. Valrubicin intravesical solution diluted in 0.9% Sodium Chloride Injection, USP for administration is stable for 12 hours at temperatures up to 25°C (77°F). Since compatibility data are not available, do not mix valrubicin intravesical solution with other drugs.

Insert a urethral catheter into the patient's bladder under aseptic conditions, drain the bladder, and instill the diluted 75 mL valrubicin intravesical solution slowly via gravity flow over a period of several minutes. Withdraw the catheter and retain valrubicin intravesical solution in the bladder for two hours before voiding. At the end of two hours, all patients should void. Some patients may be unable to retain the drug for the full two hours. Instruct patients to maintain adequate hydration following valrubicin intravesical solution treatment .

How to take Valrubicin Intravesical — instructions & advice from the label

Risk of Metastatic Bladder Cancer with Delayed Cystectomy

•Inform patients that valrubicin intravesical solution has been shown to induce complete responses in only about 1 in 5 patients, and that delaying cystectomy could lead to development of metastatic bladder cancer, which is lethal. Discuss the relative risk of cystectomy versus the risk of metastatic bladder cancer and that the risk increases the longer cystectomy is delayed in the presence of persisting CIS.

Local Adverse Reactions Before and During Treatment

•Inform patients that the major acute toxicities from valrubicin intravesical solution are related to irritable bladder symptoms that may occur during instillation and retention of valrubicin intravesical solution and for a limited period following voiding .

•Inform patients that for the first 24 hours following administration, red-tinged urine is typical.

•Advise patients to report prolonged irritable bladder symptoms or prolonged passage of red-colored urine immediately to their physician.

•Instruct patients to maintain adequate hydration following valrubicin intravesical solution treatment. …

Warnings & precautions

Do not take this medicine if: Valrubicin intravesical solution is contraindicated in patients with:

•Perforated bladder

•Known hypersensitivity to anthracyclines or polyoxyl castor oil

•Active urinary tract infection

•Small bladder capacity and unable to tolerate a 75 mL instillation

Inform patients that valrubicin intravesical solution has been shown to induce complete response in only about 1 in 5 patients with BCG-refractory CIS, and that delaying cystectomy could lead to development of metastatic bladder cancer, which is lethal. The exact risk of developing metastatic bladder cancer from such a delay may be difficult to assess but increases the longer cystectomy is delayed in the presence of persisting CIS. If there is not a complete response of CIS to treatment after 3 months or if CIS recurs, reconsider cystectomy.

Evaluate the bladder before the intravesical instillation of drug and do not administer valrubicin intravesical solution to patients with a perforated bladder or to those in whom the integrity of the bladder mucosa has been compromised . In case of bladder perforation, delay the administration of valrubicin intravesical solution until bladder integrity has been restored. One patient with a perforated bladder who received 800 mg of valrubicin intravesical solution intravesically developed severe leukopenia and neutropenia approximately two weeks after drug administration .

To avoid systemic exposure to valrubicin intravesical solution for the patients undergoing TURB, evaluate the status of the bladder before the intravesical instillation of drug. Delay administration at least two weeks after transurethral resection and/or fulguration.

Use valrubicin intravesical solution with caution in patients with severe irritable bladder symptoms. …

Valrubicin Intravesical side effects

Because clinical trials are conducted under widely varying conditions, adverse reaction rates observed in the clinical trials of a drug cannot be directly compared to rates in the clinical trials of another drug and may not reflect the rates observed in practice.

The safety of valrubicin intravesical solution was assessed in 230 patients with transitional cell carcinoma of the bladder, including 205 patients who received multiple weekly doses. One hundred seventy-nine of the 205 patients received the approved dose and schedule of 800 mg weekly for multiple weeks.

Approximately 84% of patients who received intravesical valrubicin intravesical solution in clinical studies experienced local adverse reactions. The local adverse reactions associated with valrubicin intravesical solution usually occur during or shortly after instillation and resolve within 1 to 7 days after the instillate is removed from the bladder. Seven out of 143 patients (5%) who were scheduled to receive six doses of valrubicin intravesical solution failed to receive all of the planned doses because of the occurrence of local bladder symptoms.

TABLE 1 displays the frequency of the local adverse reactions at baseline and during treatment among 179 patients who received 800 mg doses of valrubicin intravesical solution in a multiple-cycle treatment regimen. …

Drug interactions

No drug interaction studies were conducted.

About this medicine

Valrubicin Intravesical Solution, USP contains valrubicin (N-trifluoroacetyladriamycin-14-valerate), which is a semisynthetic analog of the anthracycline doxorubicin as a cytotoxic agent. The chemical name of valrubicin is (2S-cis)-2-[1,2,3,4,6,11-hexahydro-2,5,12-trihydroxy-7-methoxy-6,11-dioxo-4-[[2,3,6-trideoxy-3-[(trifluoroacetyl)amino]-α-L-lyxo-hexopyranosyl]oxyl]-2-naphthacenyl]-2-oxoethylpentanoate. Valrubicin is an orange or orange-red powder that is highly lipophilic, soluble in methylene chloride, ethanol, methanol and acetone, and relatively insoluble in water. Its chemical formula is C34H36F3NO13 and its molecular weight is 723.65. The chemical structure is shown in FIGURE 1.

FIGURE 1. Chemical Structure of Valrubicin

Valrubicin Intravesical Solution, USP is intended for intravesical administration in the urinary bladder. It is supplied as a nonaqueous solution that should be diluted before intravesical administration. …

Disclaimer: This page is for general information only and is not medical advice. It is a condensed summary of the official FDA-approved label — it does not replace the full prescribing information or the advice of your doctor or pharmacist. Always follow your prescriber's instructions and read the medication guide that comes with your medicine.

Source: FDA-approved label via DailyMed (U.S. National Library of Medicine), label set ID 8739ae02-e4c5-0fa2-e053-2a91aa0a1b74. Read the full official label on DailyMed.

Related medicines

Levothyroxine Allopurinol Ondansetron Finasteride Clonidine Testosterone Thyroid Methotrexate