Polymyxin B and Trimethoprim
Brand names: Polymyxin B Sulfate And Trimethoprim Sulfate · Active ingredient: Polymyxin B Sulfate, Trimethoprim
In short: Polymyxin B Sulfate and Trimethoprim Ophthalmic Solution, USP is indicated in the treatment of surface ocular bacterial infections, including acute bacterial conjunctivitis, and blepharoconjunctivitis, caused by susceptible strains of the following microorganisms: Staphylococcus aureus, Staphylococc
What is Polymyxin B and Trimethoprim used for?
Polymyxin B Sulfate and Trimethoprim Ophthalmic Solution, USP is indicated in the treatment of surface ocular bacterial infections, including acute bacterial conjunctivitis, and blepharoconjunctivitis, caused by susceptible strains of the following microorganisms:
Staphylococcus aureus, Staphylococcus epidermidis, Streptococcus pneumoniae, Streptococcus viridans, Haemophilus influenzae and Pseudomonas aeruginosa.
*
*Efficacy for this organism in this organ system was studied in fewer than 10 infections.
âš Boxed warning (FDA's strongest warning)
NOT FOR INJECTION INTO THE EYE. If a sensitivity reaction to polymyxin B sulfate and trimethoprim ophthalmic solution occurs, discontinue use. Polymyxin B Sulfate and Trimethoprim Ophthalmic Solution is not indicated for the prophylaxis or treatment of ophthalmia neonatorum.
Polymyxin B and Trimethoprim dosage
In mild to moderate infections, instill one drop in the affected eye(s) every three hours (maximum of 6 doses per day) for a period of 7 to 10 days.
Warnings & precautions
Do not take this medicine if: Polymyxin B Sulfate and Trimethoprim Ophthalmic Solution is contraindicated in patients with known hypersensitivity to any of its components.
As with other antimicrobial preparations, prolonged use may result in overgrowth of nonsusceptible organisms, including fungi. If superinfection occurs, appropriate therapy should be initiated.
Avoid contaminating the applicator tip with material from the eye, fingers, or other source. This precaution is necessary if the sterility of the drops is to be maintained.
If redness, irritation, swelling or pain persists or increases, discontinue use immediately and contact your physician. Patients should be advised not to wear contact lenses if they have signs and symptoms of ocular bacterial infections.
Repackaged By / Distributed By: RemedyRepack Inc.
625 Kolter Drive, Indiana, PA 15701
(724) 465-8762
Carcinogenesis:
Long-term studies in animals to evaluate carcinogenic potential have not been conducted with polymyxin B sulfate or trimethoprim.
Mutagenesis:
Trimethoprim was demonstrated to be non-mutagenic in the Ames assay. In studies at two laboratories no chromosomal damage was detected in cultured Chinese hamster ovary cells at concentrations approximately 500 times human plasma levels after oral administration; at concentrations approximately 1,000 times human plasma levels after oral administration in these same cells, a low level of chromosomal damage was induced at one of the laboratories. Studies to evaluate mutagenic potential have not been conducted with polymyxin B sulfate.
Impairment of Fertility:
Polymyxin B sulfate has been reported to impair the motility of equine sperm, but its effects on male or female fertility are unknown. …
Polymyxin B and Trimethoprim side effects
The most frequent adverse reaction to polymyxin B sulfate and trimethoprim ophthalmic solution is local irritation consisting of increased redness, burning, stinging, and/or itching. This may occur on instillation, within 48 hours, or at any time with extended use. There are also multiple reports of hypersensitivity reactions consisting of lid edema, itching, increased redness, tearing, and/or circumocular rash. Photosensitivity has been reported in patients taking oral trimethoprim.
To report SUSPECTED ADVERSE REACTIONS, contact Somerset Therapeutics, LLC at 1-800-417-9175 or FDA at 1-800-FDA-1088 or www.fda.gov/medwatch
About this medicine
Polymyxin B Sulfate and Trimethoprim Ophthalmic Solution, USP is a sterile antimicrobial solution for topical ophthalmic use. It has pH of 4.0 to 6.2 and osmolality of 270 to 310 mOsm/kg.
Chemical Names:
Trimethoprim, 5-(3,4,5-Trimethoxybenzyl)pyrimidine-2,4-,diamine, is a white, odorless, crystalline powder with a molecular weight of 290.3 and the following structural formula:
Polymyxin B sulfate is the sulfate salt of polymyxin B
1and B
2which are produced by the growth of
Bacillus polymyxa(Prazmowski) Migula (Fam. Bacillaceae). It has a potency of not less than 6,000 polymyxin B units per mg, calculated on an anhydrous basis. The structural formulae are:
Contains: Actives:polymyxin B sulfate 10,000 units/mL; trimethoprim sulfate equivalent to trimethoprim 1 mg/mL.
Preservative:benzalkonium chloride 0.04 mg/mL.
Inactives:water for injection; sodium chloride; and sulfuric acid. May also contain sodium hydroxide to adjust the pH.
How it works: Trimethoprim is a synthetic antibacterial drug active against a wide variety of aerobic gram-positive and gram-negative ophthalmic pathogens. …
Source: FDA-approved label via DailyMed (U.S. National Library of Medicine), label set ID c68818b2-d849-41d2-be07-731244afbbac. Read the full official label on DailyMed.
Related medicines
Amoxicillin Azithromycin Doxycycline Amoxicillin and Clavulanate Cephalexin Valacyclovir Sulfamethoxazole and Trimethoprim Nitrofurantoin