Epirubicin
In short: Epirubicin Hydrochloride Injection is indicated as a component of adjuvant therapy in patients with evidence of axillary node tumor involvement following resection of primary breast cancer.
What is Epirubicin used for?
Epirubicin Hydrochloride Injection is indicated as a component of adjuvant therapy in patients with evidence of axillary node tumor involvement following resection of primary breast cancer.
âš Boxed warning (FDA's strongest warning)
Severe local tissue necrosis will occur if there is extravasation during administration . Epirubicin must not be given by the intramuscular or subcutaneous route.
Myocardial toxicity, manifested in its most severe form by potentially fatal congestive heart failure (CHF), may occur either during therapy with epirubicin or months to years after termination of therapy. The probability of developing clinically evident CHF is estimated as approximately 0.9% at a cumulative dose of 550 mg/m2, 1.6% at 700 mg/m2, and 3.3% at 900 mg/m2. In the adjuvant treatment of breast cancer, the maximum cumulative dose used in clinical trials was 720 mg/m2. The risk of developing CHF increases rapidly with increasing total cumulative doses of epirubicin in excess of 900 mg/m2; this cumulative dose should only be exceeded with extreme caution. Active or dormant cardiovascular disease, prior or concomitant radiotherapy to the mediastinal/pericardial area, previous therapy with other anthracyclines or anthracenediones, or concomitant use of other cardiotoxic drugs may increase the risk of cardiac toxicity. Cardiac toxicity with Epirubicin Hydrochloride Injection may occur at lower cumulative doses whether or not cardiac risk factors are present.
Secondary acute myelogenous leukemia (AML) has been reported in patients with breast cancer treated with anthracyclines, including epirubicin. …
Epirubicin dosage
Epirubicin Hydrochloride Injection is administered to patients by intravenous infusion. Epirubicin Hydrochloride Injection is given in repeated 3- to 4-week cycles. The total dose of Epirubicin Hydrochloride Injection may be given on Day 1 of each cycle or divided equally and given on Days 1 and 8 of each cycle. The recommended dosages of Epirubicin Hydrochloride Injection are as follows:
The recommended starting dose of Epirubicin Hydrochloride Injection is 100 to 120 mg/m2. The following regimens were used in the trials supporting use of Epirubicin Hydrochloride Injection as a component of adjuvant therapy in patients with axillary-node positive breast cancer:
CEF-120:
Cyclophosphamide 75 mg/m2 PO D 1 to 14
Epirubicin Hydrochloride Injection 60 mg/m2 IV D 1, 8
5-Fluorouracil 500 mg/m2 IV D 1, 8
Repeated every 28 days for 6 cycles
FEC-100:
5-Fluorouracil 500 mg/m2
Epirubicin Hydrochloride Injection 100 mg/m2
Cyclophosphamide 500 mg/m2
All drugs administered intravenously on Day 1 and repeated every 21 days for 6 cycles
Patients administered the 120-mg/m2 regimen of Epirubicin Hydrochloride Injection also received prophylactic antibiotic therapy with trimethoprim-sulfamethoxazole (e.g., Septra® Bactrim™) or a fluoroquinolone.
* Spectra® is a registered trademark of Monarch Pharmaceuticals, Inc.
* Bactrimâ„¢ is a trademark of AR Scientific.
Consideration should be given to administration of lower starting doses (75 to 90 mg/m2) for heavily pretreated patients, patients with pre-existing bone marrow depression, or in the presence of neoplastic bone marrow infiltration .
Definitive recommendations regarding use of Epirubicin Hydrochloride Injection in patients with hepatic dysfunction are not available because patients with hepatic abnormalities were excluded from participation in adjuvant trials of FEC-100/CEF-120 therapy. In patients with elevated serum AST or serum total bilirubin concentrations, the following dose reductions were recommended in clinical trials, although few patients experienced hepatic impairment:
Bilirubin 1.2 to 3 mg/dL or AST 2 to 4 times upper limit of normal 1/2 of recommended starting dose
Bilirubin > 3 mg/dL or AST > 4 times upper limit of normal 1/4 of recommended starting dose
Information regarding experience in patients with hepatic dysfunction is provided in CLINICAL PHARMACOLOGY, Pharmacokinetics In Special Populations.
While no specific dose recommendation can be made based on the limited available data in patients with renal impairment, lower doses should be considered in patients with severe renal impairment (serum creatinine > 5 mg/dL).
Dosage adjustments after the first treatment cycle should be made based on hematologic and nonhematologic toxicities. …
Warnings & precautions
Do not take this medicine if: Patients should not be treated with Epirubicin Hydrochloride Injection if they have any of the following conditions: baseline neutrophil count < 1500 cells/mm3; severe myocardial insufficiency, recent myocardial infarction, severe arrhythmias; previous treatment with anthracyclines up to the maximum cumulative dose; hypersensitivity to epirubicin, other anthracyclines, or anthracenediones; or severe hepatic dysfunction .
Epirubicin Hydrochloride Injection is administered by intravenous infusion. Venous sclerosis may result from an injection into a small vessel or from repeated injections into the same vein. Extravasation of epirubicin during the infusion may cause local pain, severe tissue lesions (vesication, severe cellulitis) and necrosis. It is recommended that Epirubicin Hydrochloride Injection be slowly administered into the tubing of a freely running intravenous infusion. Patients receiving initial therapy at the recommended starting doses of 100 to 120 mg/m2 should generally have epirubicin infused over 15 to 20 minutes. For patients who require lower epirubicin starting doses due to organ dysfunction or who require modification of epirubicin doses during therapy, the epirubicin infusion time may be proportionally decreased, but should not be less than 3 minutes. . If possible, veins over joints or in extremities with compromised venous or lymphatic drainage should be avoided. A burning or stinging sensation may be indicative of perivenous infiltration, and the infusion should be immediately terminated and restarted in another vein. Perivenous infiltration may occur without causing pain.
Facial flushing, as well as local erythematous streaking along the vein, may be indicative of excessively rapid administration. It may precede local phlebitis or thrombophlebitis. …
Epirubicin side effects
Integrated safety data are available from two studies (Studies MA-5 and GFEA-05, see CLINICAL STUDIES) evaluating epirubicin-containing combination regimens in patients with early breast cancer. Of the 1260 patients treated in these studies, 620 patients received the higher-dose epirubicin regimen (FEC-100/CEF-120), 280 patients received the lower dose epirubicin regimen (FEC-50), and 360 patients received CMF. Serotonin-specific antiemetic therapy and colony-stimulating factors were not used in these trials. Clinically relevant acute adverse events are summarized in Table 5.
Event | % of Patients
FEC-100/CEF-120 | FEC-50 | CMF
(N=620) | (N=280) | (N=360)
Grades 1 to 4 | Grades 3 or 4 | Grades 1 to 4 | Grades 3 or 4 | Grades 1 to 4 | Grades 3 or 4
FEC & CEF =cyclophosphamide + epirubicin + fluorouracil; CMF = cyclophosphamide + methotrexate + fluorouracil NA = not available
Hematologic
Leukopenia | 80.3 | 58.6 | 49.6 | 1.5 | 98.1 | 60.3
Neutropenia | 80.3 | 67.2 | 53.9 | 10.5 | 95.8 | 78.1
Anemia | 72.2 | 5.8 | 12.9 | 0 | 70.9 | 0.9
Thrombocytopenia | 48.8 | 5.4 | 4.6 | 0 | 51.4 | 3.6
Endocrine
Amenorrhea | 71.8 | 0 | 69.3 | 0 | 67.7 | 0
Hot flashes | 38.9 | 4.0 | 5.4 | 0 | 69.1 | 6.4
Body as a Whole
Lethargy | 45.8 | 1.9 | 1.1 | 0 | 72.7 | 0.3
Fever | 5.2 | 0 | 1.4 | 0 | 4.5 | 0
Gastrointestinal
Nausea/vomiting | 92.4 | 25.0 | 83.2 | 22.1 | 85.0 | 6.4
Mucositis | 58.5 | 8.9 | 9.3 | 0 | 52.9 | 1.9
Diarrhea | 24.8 | 0.8 | 7.1 | 0 | 50.7 | 2.8
Anorexia | 2.9 | 0 | 1.8 | 0 | …
About this medicine
Epirubicin Hydrochloride Injection is an anthracycline cytotoxic agent, intended for intravenous administration. Epirubicin Hydrochloride Injection is supplied as a sterile, clear, red solution and is available in glass vials containing 50 and 200 mg of epirubicin hydrochloride as a preservative-free, ready-to-use solution. Each milliliter of solution contains 2 mg of epirubicin hydrochloride. Inactive ingredients include sodium chloride, USP, and water for injection, USP. The pH of the solution has been adjusted to 3.0 with hydrochloric acid, NF.
Epirubicin hydrochloride is the 4-epimer of doxorubicin and is a semi-synthetic derivative of daunorubicin. The chemical name is (8S- cis)-10-[(3-amino-2,3,6-trideoxy-α-L- arabino-hexopyranosyl)oxy]-7,8,9,10- tetrahydro6,8,11-trihydroxy-8-(hydroxyacetyl)-1-methoxy-5,12-naphthacenedione hydrochloride. The active ingredient is a red-orange hygroscopic powder, with the empirical formula C27 H29 NO11 HCl and a molecular weight of 579.95. The structural formula is as follows:
How it works: Epirubicin is an anthracycline cytotoxic agent. …
Source: FDA-approved label via DailyMed (U.S. National Library of Medicine), label set ID aacee94d-15af-4ccc-9cc9-6cd52905ec4e. Read the full official label on DailyMed.
Related medicines
Levothyroxine Allopurinol Ondansetron Finasteride Clonidine Testosterone Thyroid Methotrexate