Epinephrine
Active ingredient: Epinephrine
In short: Epinephrine Injection, 1 mg/mL is indicated to increase mean arterial blood pressure in adult patients with hypotension associated with septic shock. Emergency treatment of allergic reactions (Type I), including anaphylaxis, which may result from allergic reactions to insect stings, biting insects,
What is Epinephrine used for?
Epinephrine Injection, 1 mg/mL is indicated to increase mean arterial blood pressure in adult patients with hypotension associated with septic shock.
Emergency treatment of allergic reactions (Type I), including anaphylaxis, which may result from allergic reactions to insect stings, biting insects, foods, drugs, sera, diagnostic testing substances and other allergens, as well as idiopathic anaphylaxis or exercise-induced anaphylaxis. The signs and symptoms associated with anaphylaxis include flushing, apprehension, syncope, tachycardia, thready or unobtainable pulse associated with hypotension, convulsions, vomiting, diarrhea and abdominal cramps, involuntary voiding, airway swelling, laryngospasm, bronchospasm, pruritus, urticaria or angioedema, swelling of the eyelids, lips, and tongue.
Epinephrine dosage
Inspect visually for particulate matter and discoloration prior to administration, whenever solution and container permit. Do not use if the solution is colored or cloudy, or if it contains particulate matter. Discard any unused portion.
Dilute epinephrine in 5% Dextrose Injection or 5% Dextrose and 0.9% Sodium Chloride Injection. These dextrose containing fluids provide protection against significant loss of potency by oxidation. Administration in 0.9% Sodium Chloride Injection alone is not recommended. Whole blood or plasma, if indicated to increase blood volume, should be administered separately.
Add 1 mL (1 mg) of epinephrine from its vial to 1,000 mL of a 5% Dextrose containing solution. Each mL of this dilution contains 1 mcg of epinephrine.
Correct blood volume depletion as fully as possible before any vasopressor is administered. When, as an emergency measure, intraaortic pressures must be maintained to prevent cerebral or coronary artery ischemia, epinephrine can be administered before and concurrently with blood volume replacement.
Whenever possible, give infusions of epinephrine into a large vein. Avoid using a catheter tie-in technique, because the obstruction to blood flow around the tubing may cause stasis and increased local concentration of the drug. Occlusive vascular diseases (for example, atherosclerosis, arteriosclerosis, diabetic endarteritis, Buerger’s disease) are more likely to occur in the lower than in the upper extremity; therefore, avoid the veins of the leg in elderly patients or in those suffering from such disorders. There is potential for gangrene in a lower extremity when infusions of catecholamine are given in an ankle vein.
To provide hemodynamic support in septic shock associated hypotension in adult patients, the suggested dosing infusion rate of intravenously administered epinephrine is 0.05 mcg/kg/min to 2 mcg/kg/min, and is titrated to achieve a desired mean arterial pressure (MAP). The dosage may be adjusted periodically, such as every 10 to 15 minutes, in increments of 0.05 mcg/kg/min to 0.2 mcg/kg/min, to achieve the desired blood pressure goal.
Continuous epinephrine infusion is generally required over several hours or days until the patient’s hemodynamic status improves. The duration of perfusion or total cumulative dose cannot be predicted.
After hemodynamic stabilization, wean incrementally over time, such as by decreasing doses of epinephrine every 30 minutes over a 12- to 24-hour period.
Inject epinephrine intramuscularly or subcutaneously into the anterolateral aspect of the thigh, through clothing if necessary. When administering to a child, to minimize the risk of injection related injury, hold the leg firmly in place and limit movement prior to and during an injection. …
How to take Epinephrine — instructions & advice from the label
Advise patients or their caregivers about common adverse reactions associated with the use of epinephrine, including an increase in heart rate, the sensation of a more forceful heartbeat, palpitations, sweating, nausea and vomiting, difficulty breathing, pallor, dizziness, weakness or shakiness, headache, apprehension, nervousness, or anxiety. These symptoms and signs usually subside rapidly, especially with rest, quiet and recumbent positioning.
Warn patients with a good response to initial treatment about the possibility of recurrence of anaphylaxis symptoms and instruct patients to obtain medical attention if symptoms return.
Advise patients with diabetes that they may develop increased blood glucose levels following epinephrine administration.
Rare cases of serious skin and soft tissue infections, including necrotizing fasciitis and myonecrosis caused by Clostridia (gas gangrene), have been reported at the injection site following epinephrine injection for anaphylaxis. Advise patients to seek medical care if they develop signs or symptoms of infection, such as persistent redness, warmth, swelling, or tenderness, at the epinephrine injection site . …
Warnings & precautions
Do not take this medicine if: None.
When Epinephrine Injection is administered intravenously, titrate the infusion while monitoring vital signs. Invasive arterial blood pressure monitoring and central venous pressure monitoring are recommended. Because of varying response to epinephrine, dangerously high blood pressure may occur .
When Epinephrine Injection is administered intravenously, the infusion site should be checked frequently for free flow. Avoid extravasation of epinephrine into the tissues, to prevent local necrosis. Blanching along the course of the infused vein, sometimes without obvious extravasation, may be attributed to vasa vasorum constriction with increased permeability of the vein wall, permitting some leakage. This also may progress on rare occasions to superficial slough. Hence, if blanching occurs, consider changing the infusion site at intervals to allow the effects of local vasoconstriction to subside.
Antidote for Extravasation Ischemia: To prevent sloughing and necrosis in areas in which extravasation has taken place, infiltrate the area with 10 mL to 15 mL of saline solution containing from 5 mg to 10 mg of phentolamine, an adrenergic blocking agent. Use a syringe with a fine hypodermic needle, with the solution being infiltrated liberally throughout the area, which is easily identified by its cold, hard, and pallid appearance. Sympathetic blockade with phentolamine causes immediate and conspicuous local hyperemic changes if the area is infiltrated within 12 hours.
When Epinephrine Injection is used for the treatment of anaphylaxis, the most appropriate location for administration is into the anterolateral aspect of the thigh (vastus lateralis muscle) because of its location, size, and available blood flow. …
Epinephrine side effects
The following adverse reactions associated with the infusion of epinephrine were identified in the literature. Because these reactions are reported voluntarily from a population of uncertain size, it is not always possible to estimate their frequency reliably or to establish a causal relationship to drug exposure.
Cardiovascular disorders: tachycardia, supraventricular tachycardia, ventricular arrhythmias, myocardial ischemia, myocardial infarction, limb ischemia, pulmonary edema
Gastrointestinal disorders: Nausea, vomiting
General disorders and administrative site conditions: Chest pain, extravasation,
Metabolic: hypoglycemia, hyperglycemia, insulin resistance, hypokalemia, lactic acidosis
Nervous system disorders: Headache, nervousness, paresthesia, tremor, stroke, central nervous system bleeding
Psychiatric disorders: Excitability
Renal disorders: Renal insufficiency
Respiratory: Pulmonary edema, rales
Skin and subcutaneous tissue disorders: Diaphoresis, pallor, piloerection, skin blanching, skin necrosis with extravasation
Common adverse reactions to systemically administered epinephrine include anxiety, apprehensiveness, restlessness, tremor, weakness, dizziness, sweating, palpitations, pallor, nausea and vomiting, headache, and respiratory difficulties. These symptoms occur in some persons receiving therapeutic doses of epinephrine, but are more likely to occur in patients with heart disease, hypertension, or hyperthyroidism . …
Drug interactions
Drugs antagonizing pressor effects of epinephrine
•α-blockers, such as phentolamine
•Vasodilators, such as nitrates
•Diuretics
•Antihypertensives
•Ergot alkaloids
Drugs potentiating pressor effects of epinephrine
•Sympathomimetics
•β-blockers, such as propranolol
•Tricyclic anti-depressants
•Monoamine oxidase (MAO) inhibitors
•Catechol-O-methyl transferase (COMT) inhibitors, such as entacapone
•Clonidine
•Doxapram
•Oxytocin
Drugs potentiating arrhythmogenic effects of epinephrine
Patients who are concomitantly receiving any of the following drugs should be observed carefully for the development of cardiac arrhythmias .
•β-blockers, such as propranolol
•Cyclopropane or halogenated hydrocarbon anesthetics, such as halothane
•Antihistamines
•Thyroid hormones
•Diuretics
•Cardiac glycosides, such as digitalis glycosides
•Quinidine
Drugs potentiating hypokalemic effects of epinephrine
•Potassium depleting diuretics
•Corticosteroids
•Theophylline
Epinephrine should not be used to counteract circulatory collapse or hypotension caused by phenothiazines, as a reversal of the pressor effects of epinephrine may result in further lowering of blood pressure. …
About this medicine
Epinephrine Injection, USP is a clear, colorless, sterile solution containing 1 mg/mL epinephrine.
1 mL Single-Dose Vial:
1 mL single-dose clear glass vial containing 1 mg/mL epinephrine as a sterile, nonpyrogenic, clear and colorless solution. Each mL of Epinephrine Injection, USP solution contains 1 mg epinephrine, 8.6 mg sodium chloride, 0.75 mg sodium metabisulfite, q.s hydrochloric acid as a pH adjusting agent, and water for injection. The pH range is 2.2 to 5.0.
10 mL Multiple Dose Vial:
10 mL multiple dose amber glass vial containing 10 mg/10 mL (1 mg/mL) epinephrine as a sterile, nonpyrogenic, clear and colorless solution. Each 1 mL of Epinephrine Injection, USP solution contains 1 mg epinephrine, 5.25 mg chlorobutanol hemihydrate as preservative, 7.5 mg sodium chloride, 0.5 mg sodium metabisulfite, q.s hydrochloric acid as a pH adjusting agent, and water for injection. The pH range is 2.2 to 5.0.
30 mL Multiple Dose Vial:
30 mL multiple dose amber glass vial containing 30 mg/30 mL epinephrine as a sterile, nonpyrogenic, clear and colorless solution. …
Source: FDA-approved label via DailyMed (U.S. National Library of Medicine), label set ID cc4ebb51-6020-4339-a36a-ec2380b7d28e. Read the full official label on DailyMed.
Related medicines
Amlodipine Lisinopril Metoprolol Hydrochlorothiazide Tamsulosin Carvedilol Potassium Chloride Spironolactone